Practise 25 questions on Pollution Waste and Environmental Management.
0 / 25 correct · click an option to check it · +0 pts today
Q1. Which seeding method burns calcium chloride flares at the base of warm clouds, as described in the IITM CAIPEEX report?
Show answer and explanation
Answer: A
The answer is hygroscopic seeding. IITM describes it for warm clouds. Calcium chloride flares burn at the cloud base. The released particles pull in water vapour and form droplets. Glaciogenic seeding is the cold-cloud method that uses silver iodide.
Q2. Cloud seeding that adds large salt particles to warm, low-altitude clouds to speed up droplet growth is best described as
Show answer and explanation
Answer: C
Hygroscopic seeding uses large salt particles as condensation nuclei in warmer clouds, accelerating droplet coalescence until rain falls. Glaciogenic seeding, by contrast, uses ice nuclei like silver iodide in cold, supercooled clouds.
Q3. In 2025, the Delhi cabinet approved cloud-seeding sorties with IIT Kanpur at what outlay, and how many sorties?
Show answer and explanation
Answer: D
Delhi’s cabinet approved five cloud-seeding sorties with IIT Kanpur at an outlay of about ₹3.21 crore, aimed at testing artificial rain against winter smog.
Q4. Which agency runs Delhi’s cloud-seeding pilot with the Delhi Environment Department, and what total outlay did All India Radio report for five trials?
Show answer and explanation
Answer: D
IIT Kanpur runs the pilot with the Delhi Environment Department. The AIR report gives a total outlay of ₹3.21 crore for five trials. A separate AIR figure of ₹2.75 crore is the estimate for the trials alone. That estimate works out at ₹55 lakh per trial.
Q5. How many flares did Delhi’s environment minister say were used in the flight of 28 October 2025?
Show answer and explanation
Answer: B
The minister put the count at eight flares. DD News gives the flight date as Tuesday 28 October 2025. The aircraft was a Cessna flown by IIT Kanpur. It came in from the Meerut side. The number five belongs to the planned sorties, not the flares.
Q6. Which problem did the expert opinion of 30 October 2024 raise about seeding in Delhi’s winter?
Show answer and explanation
Answer: A
The experts pointed to short-lived Western Disturbances as the source of winter clouds. When low clouds do form, natural rain often falls anyway. They also said clouds above 5-6 km cannot be seeded. The cold, dry winter generally lacks the needed cloud conditions. A dry layer below the cloud could evaporate the rain.
Q7. At Solapur, what did radar show downwind of hygroscopic seeding in CAIPEEX IV?
Show answer and explanation
Answer: C
Radar showed about 18 ± 2.6% more rain over a 100 sq km area downwind. The larger gain of 46 ± 13% came from some rain gauges only. The 46% is a maximum at some gauges. The 18% is an average over the 100 sq km area. The report also estimates about 867 million litres of extra water.
Q8. Consider the following statements about the Supreme Court’s directions on GRAP in the M.C. Mehta case. 1. On 5 December 2024, the Court directed precautionary invocation of Stage III above AQI 350 and Stage IV above 400. 2. These directions permanently replaced the AQI bands in the CAQM schedule. 3. The Court relaxed these directions on 17 February 2025. Which of the statements given above is/are correct?
Show answer and explanation
Answer: B
Statements 1 and 3 are correct. The 350/400 figures were precautionary judicial directions of 5 December 2024, relaxed “for the time being” on 17 February 2025. Statement 2 is wrong because they were separate from the schedule bands and did not replace them. The schedule bands remain 401-450 for Stage III and above 450 for Stage IV.
Q9. Which body issues GRAP directions for Delhi-NCR, with its GRAP subcommittee deciding when to invoke each stage?
Show answer and explanation
Answer: D
CAQM issues GRAP. Its GRAP subcommittee reviews Delhi’s AQI and IMD/IITM forecasts before invoking a stage. CPCB has national technical functions. DPCC regulates pollution only within Delhi, through consent, inspections and monitoring.
Q10. An organiser of a gathering of more than how many persons must inform the local body about waste?
Show answer and explanation
Answer: B
The Rules apply to gatherings of more than 100 persons.
Q11. What are the major types of environmental pollution?
Show answer and explanation
Answer: A
Environmental pollution has several major types. These include air, water, and soil pollution. Noise pollution is also a major type.
Q12. Consider the following statements regarding mercury pollution. How many of the above statements are correct? 1. Gold mining activity is a source of mercury pollution in the world. 2. Coal-based thermal power plants cause mercury pollution. 3. There is no known safe level of exposure to mercury.
Show answer and explanation
Answer: C
All three statements are correct. Artisanal gold mining is the world’s largest source of mercury emissions (35%+ of the global total). Coal-based thermal power plants are also a major source, since coal contains trace mercury released on burning. And per WHO/NCBI, there is no known safe level of mercury exposure — it is a cumulative neurotoxin.
Q13. What is the world’s largest single source of anthropogenic mercury emissions?
Show answer and explanation
Answer: A
Artisanal and small-scale gold mining is the world’s largest source of mercury emissions, over 35% of the global total.
Q14. Which of the following is NOT a significant source of benzene exposure?
Show answer and explanation
Answer: D
Exhaust, tobacco smoke and wood burning are documented benzene sources. WHO names exhaust and cigarette smoke, and the US EPA lists benzene in wood smoke. The UPSC key for CSP 2020 item 48 counts varnished furniture as not a reason. WHO’s indoor guidelines list furniture and building materials as indoor benzene sources, but their emissions fade over weeks to a year.
Q15. Which of these is the leading source of indoor benzene exposure?
Show answer and explanation
Answer: D
WHO says benzene has been found at high levels in indoor air. It adds that most of it is from cigarette smoke, in homes and public spaces. The US National Cancer Institute says cigarette smoke accounts for about half of total US population exposure.
Q16. Which of the following are genuine factors for exposure to benzene pollution? 1. Automobile exhaust 2. Tobacco smoke 3. Wood burning 4. Varnished wooden furniture 5. Polyurethane products
Show answer and explanation
Answer: A
WHO names automobile exhaust among the main environmental sources of benzene. WHO also says most benzene in indoor air is from cigarette smoke. The US EPA says wood smoke contains benzene. UPSC’s key for CSP 2020 item 48 (Set A) is A, 1, 2 and 3 only. It treats varnished furniture and polyurethane products as not being reasons.
Q17. Which single pollutant is documented as a genuine byproduct of crop residue burning, coal-fired power plants, AND furnace oil combustion?
Show answer and explanation
Answer: C
The correct answer is sulphur dioxide. Crop residue holds sulphur, and about half is lost through emissions when it burns. The US EPA says the largest source of SO2 is burning fossil fuels in power plants and industry. The ‘ozone’ option is wrong because ozone is not emitted directly. It forms in the air from NOx and VOCs. The ‘methane’ and ‘carbon monoxide’ options are wrong here because the sources checked tie SO2, not these, to residue, coal and oil together. Memory hook: sulphur in the fuel, sulphur dioxide in the air.
Q18. Which gases are released into the atmosphere due to the burning of crop or biomass residue?
Show answer and explanation
Answer: C
The correct answer is carbon monoxide, methane, ozone and sulphur dioxide. Burning gives off CO, methane and SO2 directly, and ozone forms later from the smoke’s nitrogen oxides and VOCs in sunlight. The ‘only ozone and sulphur dioxide’ option is wrong because it leaves out CO and methane. The ‘only carbon monoxide and methane’ option is wrong because it leaves out SO2 and ozone. The ‘none’ option is wrong because the fires do release these gases. Memory hook: three come out of the fire, one is made afterwards.
Q19. Consider the following statements: Statement I: Circular economy reduces the emissions of greenhouse gases. Statement II: Circular economy reduces the use of raw materials as inputs. Statement III: Circular economy reduces wastage in the production process. Which one of the following is correct in respect of the above statements?
Show answer and explanation
Answer: A
The correct answer is (a) Both Statement II and Statement III are correct and both of them explain Statement I.
A circular economy keeps materials in use longer through reuse, recycling, repair, and remanufacturing. This genuinely reduces how much raw material needs to be extracted and processed (Statement II), and it reduces wastage during production, since design shifts toward efficiency and reuse (Statement III).
Both of these mechanisms directly explain the lower greenhouse gas emissions in Statement I: less raw material extraction and processing means less associated energy use and emissions, and less production waste means less energy wasted producing material that’s discarded.
Q20. Consider the following statements: Statement I: Studies indicate that carbon dioxide emissions from cement industry account for more than 5% of global carbon emissions. Statement II: Silica-bearing clay is mixed with limestone while manufacturing cement. Statement III: Limestone is converted into lime during clinker production for cement manufacturing. Which one of the following is correct in respect of the above statements? [UPSC CSP 2025]
Show answer and explanation
Answer: B
The correct answer is Both Statement II and Statement III are correct but only one of them explains Statement I. Cement makers heat limestone with a little clay or shale. That is Statement II. In the kiln, limestone breaks into lime and CO2. That is Statement III. The GCCA says the sector’s direct CO2 comes mainly from the heated limestone (about 60%) and kiln fuel (about 40%). So only Statement III explains the emissions. Mixing clay is a physical step. Memory hook: the clay is mixed, the limestone is cooked, and the cooking makes the CO2.
Q21. What net emissions figure did India’s BUR-4 report for 2020, and what caused the year-on-year drop?
Show answer and explanation
Answer: D
The correct answer is 2,437 million tonnes CO2-equivalent, a 7.93% drop from 2019, attributed to reduced economic activity during COVID-19 lockdowns rather than a structural policy shift. The 1-billion-tonne figure is a different, unrelated number: it is the Panchamrit’s separate 2030 target for cutting projected emissions, not the BUR-4 2020 inventory figure.
Q22. What best describes India’s approach to spent nuclear fuel?
Show answer and explanation
Answer: A
India follows a nearly closed fuel cycle: spent fuel is reprocessed to recover reusable uranium and plutonium, reducing the volume of true waste.
Q23. What is a closed nuclear fuel cycle?
Show answer and explanation
Answer: C
Fissile and fertile material is recovered from spent fuel and recycled.
Q24. India has two new fuel-cycle facilities under construction: the Integrated Nuclear Recycle Plant (INRP) and the Fast Reactor Fuel Cycle Facility (FRFCF). Which site hosts which?
Show answer and explanation
Answer: D
INRP at Tarapur handles PHWR spent fuel; FRFCF at Kalpakkam is built for fast breeder reactor fuel, matching the PFBR’s location.
Q25. The 2018 protests that led to the closure of a major copper smelting plant in Tuticorin, Tamil Nadu, cited which company?
Show answer and explanation
Answer: D
The Sterlite Copper plant in Tuticorin was shut down in 2018 after protests over air pollution and alleged groundwater contamination concerns.
Share your thoughts